![]() Temperatures between 170° and 200° are considered normal. ![]() Late model F-150s have the option to check transmission temperature from the information display. You can check the transmission temperature in newer F-150s through the information display.įigure 8. Do this by letting the truck run until the engine is warmed up. In order to test the new fluid, you will need to heat your transmission back up to operating temperature (approximately 150°). Next, use the funnel to distribute approximately 5 to 6 quarts of brand new transmission fluid. That’s a big range, so it depends on the age of your transmission and how you use your vehicle, eg: city vs. Manual transmission oil should be changed, roughly, every 50 000-95 000 kilometers. In order to perform this task, pop the hood and remove the transmission fluid dipstick. Most manufacturers recommend that manual transmission oil be changed on a slightly more frequent schedule than automatic transmission fluid. Returning the pan to its original position. Install the new filter and carefully bolt the sparkling pan back into place. This is what your pan should look like at this point in the process. ![]() Once the pan has been removed, wipe it clean to clear up any debris that might have built up over time. Utilizing a small screwdriver is your best bet at carefully removing the seal without causing damage to the surrounding components. When removing the ring, be careful not to touch the sensitive main control bore. This will be visible after pulling off the transmission filter. There is a smaller filter in the valve body that should be cleaned too (the location pictured above). You do not need to replace this, but you should clean it. The gray dish is the transmission filter. The ring depicted in Figure 5 below must also be removed. The filter is easier to remove if you shimmy it down and out simultaneously. The 15 quart container catching drips from your F 150 pan. Do not put the container down until the fluid stops gushing out. This container should catch the fluid coming out as you loosen the bolts on the transmission pan while slowly maneuvering from one end of the pan to the other. Position your 15 quart or larger container under your pickup where your transmission pan is located. The dip stick can be located on the body transmission body as illustrated by the diagram above. F-150's built after 2011 are equipped with the 6R80 transmission. The transmission fluid dip stick is visible in the engine bay on 2004-2010 F-150's. Ford F-250 transmissions-like the 5R110W and the 6R140-are similar regardless of engine configuration. This process applies to the 4R7xx family of transmissions on the F-150 as well as the newer 6R80. If you have reached 100k miles or more and that is your reason for flushing, feel free to skip ahead to Step 2. If you wish to flush the fluid because you suspect it is in dire need of changing, be certain to confirm this suspicion by checking your transmission fluid prior to performing any maintenance. This is inclusive of donning protective gear, turning off the engine, and parking in a safe, flat location. It is best to take all necessary safety precautions when performing any DIY operation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |